Check Real HP HPE0-V15 Exam Question for Free (2023)
Get Ready to Boost your Prepare for your HPE0-V15 Exam with 82 Questions
NEW QUESTION 41
Read the question, and then refer to the exhibit.
<Switch-A>display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0 <SNIP> An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.
The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.
What must you do to resolve this issue?
- A. Configure the interface as an IRF port.
- B. Configure the interface as an access port.
- C. Permit VLAN 20 on the interface.
- D. Configure the PVID of the interface to be VLAN 20.
Answer: C
NEW QUESTION 42
A customer has a single HPE ProLiant Gen 10 server.
Which embedded management tool should they use to monitor the server?
- A. HPE iLO5
- B. HPE Smart Update Manager
- C. HPE OneView Standard
- D. NPE Intelligent Provisioning
Answer: B
NEW QUESTION 43
Which feature in a block storage array is effective in decreasing the size of blocks?
- A. deduplication
- B. thick provisioning
- C. thin provisioning
- D. compression
Answer: D
NEW QUESTION 44
A customer Has a data center with third-party routers and firewalls You are designing a new data center network switch architecture consisting of FlexFabric switching for the data network and ArubaOS-Switch switching for the out-of-band management network.
The customer needs a network management platform with the capabilities to manage and monitor the entire environment Which management platform meets the customer requirements?
- A. HPE OneView
- B. HPE IMC
- C. Aruba Central
- D. Aruba Airwave
Answer: B
NEW QUESTION 45
A customer needs a low cost block storage array for targeted workloads. The array needs to provide automated tiering, thin provisioning, and snapshot capabilities.
Which HPE storage solution meets the customer requirements?
- A. HPE D3000
- B. HPE Nimble
- C. HPE StoreEasy
- D. HPE MSA
Answer: D
NEW QUESTION 46
A solution Integrator is installing new equipment to the rack Click the recommended location area for R3000 Gen5 UPS.
Answer:
Explanation:
NEW QUESTION 47
A customer requests a quote for an HPE storage solution that meets these requirements
* fully redundant dual-controller storage array with no single points of failure
* 1 Gb or 10 Gb ISCSI connectivity
* at least four host-facing ISCSI ports
* capable of expanding usable capacity in small increments of one-to-two disks Which HPE storage solution should be proposed?
- A. D3000
- B. Nimble HF20
- C. MSA 1050
- D. Nimble AF20Q
Answer: C
NEW QUESTION 48
Refer to the exhibit.
You are configuring a pair of HPE 5945 switches into an IRF stack You have cabled the switches as depicted in the exhibit Into which IRF Ports should you place each switch interface?
- A.
- B.
- C.
- D.
Answer: A
NEW QUESTION 49
A customer recently installed a VMware environment with HPE ProLiants, HPE MSA storage, and Aruba switches.
What should you recommend to the customer to manage their support contracts with HPE?
- A. HPE Recovery Manager Central
- B. HPE Insight Online
- C. Service Pack for ProLiant
- D. HPE InfoSight
Answer: B
NEW QUESTION 50
When should you choose to populate a server with LRDlMMs?
- A. when error correction is the most important factor
- B. when memory capacity is the most important factor
- C. when memory speed is the most important factor
- D. when price is the most important factor
Answer: C
NEW QUESTION 51
A customer needs to provide inventory management, health monitoring, status alerting, and reporting for their ProLiant servers.
Which HPE management offering meets the customer's needs?
- A. OneView
- B. Insight Online
- C. Insight Remote Support
- D. InfoSight
Answer: A
NEW QUESTION 52
What is the correct cable type to use when connecting a server to a switch using 10 Gbps Short Range (SR) SFP+ optical connections?
- A. Direct Attach Cable (DAC)
- B. Single Mode Fiber
- C. Multi-mode Fiber
- D. Twin-Ax
Answer: B
NEW QUESTION 53
A customer requires an entry-level, all-flash system with predictable performance at the lowest possible price. They have performance-sensitive workloads that require speed and efficiency.
Which HPE storage system needs the customer's requirements?
- A. Nimble AF1000
- B. Nimble SFA
- C. Nimble AF5000
- D. Nimble CS1000
Answer: A
NEW QUESTION 54
What does the term composable mean when applied to HPE infrastructure?
- A. pay-per-use consumption models
- B. to provide all-flash like performance, but at a hybrid price point
- C. to simplify and accelerate DevOps and business innovation
- D. hardware-defined infrastructure
Answer: C
Explanation:
Infrastructure that can be provisioned on the fly with software-defined intelligence allows for optimal application performance. Logically pooling resources reduces both underutilization and overprovisioning to create a more agile, cost-effective data center. A unified management interface integrates formerly siloed infrastructure and operations and allows IT to be offered as a service, enabling modern DevOps practices to be adopted by organizations with critical legacy applications that need to remain on premises.
NEW QUESTION 55
You are installing a DL385 GEN10 LFF server at a customer site. The customer has a P8i6i-a RAID controller in the host After installing the provided 8 LFF disks in the front drive Days, you realize that the order also included two more SFF drives for the OS to boot from, but there are no SFF drive slots in the server, because it shipped from the factory.
Which action must be performed to finish the installation?
- A. Give the two SFF drives to the customer to keep on-site in case of future drive failure.
- B. install the two SFF drives in the two included SFF slots in the universal Media Bay.
- C. Order the optional 2-SFF rear drive box to house the two SFF drives
- D. Order the optional Premium 6 SAS/SATA+2 NVMe cage to house the two SFF drives.
Answer: C
NEW QUESTION 56
In which protocol are REST API requests transported?
- A. HTTP
- B. CRUD
- C. SOAP
- D. SSH
Answer: A
NEW QUESTION 57
A customer is implementing a redundant AD servers to support then lab environment .They have the following requirements
* four rack servers, each with 2 CPUs from AMD. at least 256GB of RAM. FC Dual Port hba
* HPE Nimble AF20 with 17TB useable capacity
* integration into their existing HEP FlexFabric 57io and HPE SN3000B Fibre Channel SAN switches.
it the customer needs more capacity in the future, they will use scale-out growth Which server model should you recommend to this client?
- A. ProLiant DL 360 Gen 10
- B. Proliant DL 385 Gen10
- C. ProLiant DL 325 Gen10
- D. ProLiant DL SGOGen10
Answer: C
NEW QUESTION 58
......
HP HPE0-V15 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
Use Free HPE0-V15 Exam Questions that Stimulates Actual EXAM : https://www.actualvce.com/HP/HPE0-V15-valid-vce-dumps.html