Get Latest [Sep-2021] Conduct effective penetration tests using ActualVCE NSE7_SDW-6.4
Penetration testers simulate NSE7_SDW-6.4 exam PDF
NEW QUESTION 11
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )
- A. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub
- B. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.
- C. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links
- D. It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance
Answer: A,C
NEW QUESTION 12
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Configure the IKE mode to be aggressive mode.
- B. Use different proposals are used between the interfaces.
- C. Specify a unique peer ID for each dial-up VPN interface.
- D. Use unique Diffie Hellman groups on each VPN interface.
Answer: B,D
NEW QUESTION 13
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
- B. Dead members require manual administrator access to bring them back alive
- C. Port2 might become alive when a single response is received from an SLA server
- D. SD-WAN interface becomes disabled and port1 becomes the WAN interface
Answer: A
NEW QUESTION 14
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager
- B. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- C. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager
- D. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices
Answer: A,B
NEW QUESTION 15
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
- A. SD-WAN member interfaces are affected by the SLA state of the inactive interface
- B. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
- C. Port1 became dead 1ecause no traffic was offload through the egress of port1.
- D. Both SD-WAN member interfaces have used separate SLA targets.
Answer: B
NEW QUESTION 16
Which components make up the secure SD-WAN solution?
- A. Application, antivirus, and URL, and SSL inspection
- B. Datacenter, branch offices, and public cloud
- C. Telephone, ISDN, and telecom network.
- D. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
Answer: D
NEW QUESTION 17
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers. The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links. One link has random jitter and latency issues, and is based on a wireless connection.
Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD-WAN rules? (Choose two.)
- A. Configure an SD-WAN rule to load balance all traffic without VoIP.
- B. Place the troublesome link at the top of the interface preference list.
- C. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.
- D. Choose the suitable interface based on the interface cost and weight.
- E. Use the performance SLA targets to detect latency and jitter instantly.
Answer: C,E
NEW QUESTION 18
Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface? (Choose two )
- A. FEC is useful to increase speed at which traffic is routed through IPsec tunnels.
- B. FEC transmits additional packets as redundant data to the remote device.
- C. FEC improves reliability which overcomes adverse WAN conditions such as noisy links.
- D. FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss
- E. FEC transmits the original payload in full to recover the error in transmission.
Answer: B,C
NEW QUESTION 19
Refer to the exhibit.
Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topology
Which two statements are correct if a user in Toronto sends traffic to London? (Choose two )
- A. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
- B. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
- C. London generates an IKE information message that contains the Toronto public IP address
- D. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN
Answer: A,D
NEW QUESTION 20
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)
- A. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- B. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- C. It improves SD-WAN performance on the managed FortiGate devices.
- D. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- E. It acts as a policy compliance entity to review all managed FortiGate devices.
Answer: D,E
NEW QUESTION 21
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set cost 15.
- B. Set source 100.64.1.1.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set priority 10.
Answer: B
NEW QUESTION 22
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link health-check
- B. diagnose sys virtual-wan-link intf-sla-log
- C. diagnose sys virtual-wan-link sla-log
- D. diagnose sys virtual-wan-link log
Answer: C
Explanation:
Explanation/Reference: https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/943037/sla-logging
NEW QUESTION 23
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. FortiGate created a single IPsec virtual interface that is shared by all clients
- B. 100.64.3.1 is one of the remote IP address that comes through index interlace 1.
- C. VPN static routes are prevented from populating the FortiGate routing table
- D. There are separate virtual interfaces for each dial-up client
Answer: D
NEW QUESTION 24
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- B. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- C. It ensures route tags match the SD-WAN rule based on the rule order
- D. It tags each route and references the tag in the routing table.
Answer: C
NEW QUESTION 25
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Specify outgoing interface routing cost.
- B. Specify incoming interfaces in SD-WAN rules.
- C. Configure SD-WAN rules interface preference.
- D. Select SD-WAN balancing strategy.
Answer: C
NEW QUESTION 26
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?
- A. The URL category must be specified on the traffic shaping policy
- B. The application control profile must be enabled on the firewall policy.
- C. The shaper mode must be applied per-IP shaper on the traffic shaping policy
- D. The web filter profile must be enabled on the firewall policy
Answer: D
NEW QUESTION 27
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?
- A. Choose the suitable interface based on the interface cost and weight
- B. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule
- C. Place the troublesome link at the top of the interface preference list.
- D. Configure an SD-WAN rule to load balance all traffic without VoIP
- E. Use the performance SLA targets to detect latency and jitter instantly.
Answer: A,E
NEW QUESTION 28
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link health-check
- B. diagnose sys virtual-wan-link intf-sla-log
- C. diagnose sys virtual-wan-link sla-log
- D. diagnose sys virtual-wan-link log
Answer: C
NEW QUESTION 29
Which statement about using BGP routes in SD-WAN is true?
- A. Adding static routes must be enabled on all ADVPN interfaces.
- B. Learned routes can be used as dynamic destinations in SD-WAN rules
- C. Dynamic routing protocols can be used only with non-encrypted traffic
- D. VPN topologies must be form using only BGP dynamic routing with SD-WAN
Answer: B
NEW QUESTION 30
Refer to the exhibit.
Which two statements about the debug output are correct? (Choose two )
- A. The debug output shows per-IP shaper values and real-time readings.
- B. FortiGate provides statistics and reading based on historical traffic logs.
- C. Traffic being controlled by the traffic shaper is under 1 Kbps.
- D. This traffic shaper drops traffic that exceeds the set limits.
Answer: A,D
NEW QUESTION 31
Refer to the exhibit.
Which statement about the trace evaluation by FomGate is true?
- A. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
- B. Packets exceeding the configured concurrent connection limit are dropped based on the priority configuration.
- C. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
- D. The packet exceeded the configured bandwidth and was dropped based on the priority configuration.
Answer: A
NEW QUESTION 32
......
Tested Material Used To NSE7_SDW-6.4 Test Engine: https://www.actualvce.com/Fortinet/NSE7_SDW-6.4-valid-vce-dumps.html