Valid NSE 7 Network Security Architect NSE7_SDW-6.4 Dumps Ensure Your Passing
NSE7_SDW-6.4 Dumps Real Exam Questions Test Engine Dumps Training
NEW QUESTION 31
Which statement is correct about the SD-WAN and ADVPN?
- A. Spoke support dynamic VPN as a static interface.
- B. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
- C. ADVPN interface can be a member of SD-WAN interface.
- D. Dynamic VPN is not supported as an SD-Wan interface.
Answer: C
NEW QUESTION 32
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices
- B. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- C. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager
- D. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager
Answer: B,D
NEW QUESTION 33
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)
- A. The FortiGate cloud key has not been added to the FortiGate cloud portal.
- B. A factory reset performed on FortiGate.
- C. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
- D. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
- E. The zero-touch provisioning process has completed internally, behind FortiGate.
Answer: A,E
NEW QUESTION 34
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )
- A. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub.
- B. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.
- C. It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance.
- D. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links.
Answer: A,B
NEW QUESTION 35
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. The protected subnets should be set to address object to all (0.0 .0. 0/0).
- B. On the hub VPN, only the device needs additional phase one sett
- C. ADVPN should only be enabled on unmanaged FortiGate devices.
- D. Each VPN device has a unique pre-shared key configured separately on phase one
Answer: A
NEW QUESTION 36
Which components make up the secure SD-WAN solution?
- A. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
- B. Datacenter, branch offices, and public cloud
- C. Application, antivirus, and URL, and SSL inspection
- D. Telephone, ISDN, and telecom network.
Answer: A
NEW QUESTION 37
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- B. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
- C. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
- D. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
Answer: A,C
Explanation:
SD-WAN 6.4 Guide Page 158.
NEW QUESTION 38
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on portl that match only FIRSTJVPN.
Which two configuration changes must be made to both IPsec
VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two )
- A. Use different proposals are used between the interfaces.
- B. Configure the IKE mode to be aggressive mode
- C. Configure a unique peer ID for each dial-up VPN interface
- D. Use unique Diffie Hellman groups on each VPN interface
Answer: B,C
NEW QUESTION 39
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It ensures route tags match the SD-WAN rule based on the rule order
- B. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- C. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- D. It tags each route and references the tag in the routing table.
Answer: C
Explanation:
SD-WAN 6.4.5 Guide Page 226.
NEW QUESTION 40
Which two interfaces are considered overlay links? (Choose two.)
- A. IPsec
- B. Physical
- C. GRE
- D. LAG
Answer: A,C
NEW QUESTION 41
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It improves SD-WAN performance on the managed FortiGate devices.
- B. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices
- C. It acts as a policy compliance entity to review all managed FortiGate devices
- D. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server
- E. It sends probe signals as health checks to the beacon servers on behalf of FortiGate
Answer: B,D
NEW QUESTION 42
What are two reasons why it is effective to implement the internet service database (ISDB) in an SD-WAN rule? (Choose two )
- A. The ISDB applies rules to traffic from specific sources, based on application type.
- B. The ISDB requires application control to maintain signatures and perform load-balancing.
- C. The ISDB is dynamically updated and reduces administrative overhead.
- D. The ISDB contains the IP addresses and port ranges of well-known destinations.
Answer: C,D
NEW QUESTION 43
Which three parameters are available to configure SD-WAN rules? (Choose three.)
- A. URL categories
- B. Type of physical link connection
- C. Source and destination IP address
- D. Internet service database (ISDB) address object
- E. Application signatures
Answer: B,C,D
NEW QUESTION 44
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set source 100.64.1.1.
- B. Set cost 15.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set priority 10.
Answer: A
NEW QUESTION 45
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- B. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
- C. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
- D. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
Answer: A,C
Explanation:
SD-WAN 6.4 Guide Page 158.
https://docs2.fortinet.com/document/fortimanager/6.4.0/sd-wan-orchestrator-6-4-0-administration-guide/91581/introduction
NEW QUESTION 46
Refer to exhibits.
Exhibit A.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output Based on the exhibits, which statement is correct?
- A. Both SD-WAN member interfaces have used separate SLA targets.
- B. Port1 became dead 1ecause no traffic was offload through the egress of port1.
- C. SD-WAN member interfaces are affected by the SLA state of the inactive interface
- D. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
Answer: A
NEW QUESTION 47
Refer to Exhibit:
Which statement is correct it the responder FortiGate is using a dynamic routing protocol over the IPsec VPN interface?
- A. Only dial-up connections without XAuth can be used for the dynamic routing
- B. The phase 1 type must be changed to static for dynamic routing.
- C. peertype must be set to accept only one peer ID for a unique VPN interface
- D. add-route must be disabled to prevent FortiGate from installing VPN static routes
Answer: D
NEW QUESTION 48
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Use different proposals are used between the interfaces.
- B. Use unique Diffie Hellman groups on each VPN interface.
- C. Configure the IKE mode to be aggressive mode.
- D. Specify a unique peer ID for each dial-up VPN interface.
Answer: A,B
NEW QUESTION 49
......
Fortinet NSE7_SDW-6.4: Selling NSE 7 Network Security Architect Products and Solutions: https://www.actualvce.com/Fortinet/NSE7_SDW-6.4-valid-vce-dumps.html